High Temperature Furnace Lining Design and Processing
Ceramic fiber module
describe
CT ceramic fiber module adopts high-quality ceramic fiber blanket, which is composed of compression module after folding, compression and packaging
The module can choose a variety of combinations of anchor bolt and furnace body. The installation method is simple, which greatly accelerates the construction speed of furnace lining
After installation, cut the bandage and cut the module into an integral insulating lining.
The anchoring system keeps the metal components at a lower temperature away from the hot surface of the module
Characteristics of the
The rear fixtures can be used for plumbing and parquet installation.
Blanket folding pressure relief offers two configurations of tightly sealed in-mold joints
The elastic blanket can resist mechanical damage
Low thermal conductivity, high thermal efficiency
Complete thermal shock resistance
No need to dry or solidify - can be used in production immediately after installation
Anchor points away from module hot surface
Typical applications
Heat treatment: annealing furnace, annealing furnace, soaking furnace, etc
Ceramics: white ceramics, sanitary ceramics and brick tunnels and intermittent kilns.
Steel: transfer ladle cover, soaking furnace cover, heating furnace, continuous annealing furnace, pull furnace
Petrochemical industry: ethylene pyrolysis furnace, reformer, atmospheric pressure decompression furnace, pipe pyrolysis heater
Aluminum: soaking pit and covering, furnace covered, homogenization and duct system
Utility: waste heat recovery unit, combustion chamber and boiler duct
