Induction Furnace for Mold Casting

The main point of this induction furnace is that the volume is larger than the melting rate, which is designed according to the mold time, and the power density is usually low The waste should be clean and pure, usually most of it comes from industry recycling The furnace structure usually includes a fixed cover and an annular dust cover.

Induction-Furnace-for-Mold-Casting.jpg

This type of induction furnace pays more attention to melting speed and high power density Raw materials can be varied In each melting cycle, the supply of waste materials is very frequent, and there is a lot of smoke and dust. The fixed cover and ring dust mask are no longer suitable for use.


 


Rated
capacity
( t )

Rated
power
( KW )

Rated
frequency
( HZ )

Transformer configuration

pulses

Coil
voltage
( V )

(1600ºC)
Melting
rate
( t/h )

Energy
consumption
( kWh/t )

Capacity
( KVA )

Secondary voltage
( V )
3220050025003φ690V624002.8650
5350050040003φ1000V632004.5630
10630050070006φ1000V1232009600
1590002502×50002×6φ1000V24320012565
20110002502×63002×6φ1000V24320015560
30140001502×80002×6φ1000V24320020550
40180001502×100002×6φ1000V24320025540
50200001502×110002×6φ1000V24320030530
60220001002×120002×6φ1000V24400035520
70240001002×130002×6φ1000V24400040510



Contact us